Separating Detachable Extruder (Mounting) - Cubicon Single Operation Manual

6.7. Separating Detachable Extruder (Mounting)

An electric shock can damage the printer if the detachable extruder is separated or mounted while the
power is [ON].
Separate or mount the detachable Extruder when the power is off.
You can easily separate the detachable extruder part from the fixed extruder part by unfastening the
screw with a screwdriver. The process of separating the detachable extruder part is described below.
To mount the part, just follow the same steps in reverse order.
① To separate the detachable extruder part, pull out the
Teflon tube inserted into the filament entry of the extruder
and run unloading to remove the filament inside the
extruder.
* It should be noted that separating the detachable extruder part while the filament is inserted into the
extruder can damage the sensor or the equipment.
* If unloading is not possible because of a printer problem, etc., cut off the filament at the filament entry of
the extruder and carefully separate the detachable extruder by pressing the filament handle.
② Turn [OFF](O) the printer.
An electric shock can damage the printer if the
detachable extruder is separated while the power is [ON]
③ Unfasten the screw by turning it counterclockwise by
hand using a screwdriver.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
(150616,En)
27 / 44