Internal Printer Parts And Extruder - Cubicon Single Operation Manual

4.2. Internal Printer Parts and Extruder

1
2
3
[1] Teflon tube
[2] Extruder part
[3] Heating bed
Extruder part
[E1] Filament insertion hole
[E2] Filament handle
[E3] Mold Lighting LED
[E4] Ventilation guide
[E5] Nozzle
[E6] Detachable screw
[E7] Fixed extruder part
[E8] Detachable extruder part
Do not touch the nozzle and heating bed of the detachable extruder during the printing operation, as these
are hot.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
E2
The path to supply the filament to the printer extruder (be careful not to bend,
etc.)
The extruder exudes the filament and melts it through the nozzle
The platform to output the printed material during printing
Hole through which filament is inserted into the extruder; a Teflon tube is
placed inside it
Handle to manually pull the filament out of the extruder or insert it
White LED to check the molding status;located in the detachable extruder part
A fixture sending the air from the molding fan to the molded parts; located in
the detachable extruder part
Nozzle through which the melted filament flows;located in the detachable
extruder part
Fastening screws used to mount and dismount the detachable extruder part
Fixed part of the extruder
Detachable part of the extruder
E1
E3
E4
E5
(150616,En)
E6
E7
E8
11 / 44