Table of Contents
Advertisement
The printer is packaged after LOT test of output conditions.
This testing may leave traces of usage on the heating bed, nozzle, etc.
Be assured that these are traces of testing, and that there is no problem with the product.
2
5A
5B
[1] Top door
[2] Front door
[3] LCD and operating buttons
[4] Vent for filter fan
[5] Interface part
[5A] Firmware switch
[5B] SD Memory slot
[5C] USB input (Type-B)
[5D] Power switch
[6] Filament insertion hole
[7] Spool holder mounting hole
[8] Power input
Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.
1
3
4
5
5C
5D
Used for maintenance such as the filament replacement (loading /
unloading)
Used to pull out the molded part
LCD screen and touch buttons to operate printer
Internal air vent while filter fan operates.
Interface and power button.
Switch for updating the firmware of printer.
Slot to insert SD Memory card.
USB input terminal to connect to a PC
Power switch for the printer.
Hole to feed the filament into the printer.
Hole to hang the filament spool holder.
Terminal to connect the cable of DC power adapter
External Printer Parts
6
7
8
4
Advertisement
Table of Contents
