Installation Of Printer; Mounting Of Clean Filter - Cubicon Single Operation Manual

⑦ Remove the package and tape.
Set the horizontal levelness of the printer by adjusting the feet,
while referring to the inclinometer.
* The driving part is fixed with packaging material only, without using a cable tie, in order to prevent
potential problems when the printer is operated. Please be careful not to damage the part when removing
the internal packaging material.
* The Teflon tube is located near the extruder fixing packaging material. Since the Teflon tube is the
moving path of the filament, it should be handled carefully to avoid damage caused by being excessively
pulled, bent or pressed.

5.2. Installation of Printer

5.2.1. Mounting of Clean Filter

① Pull out the clean filter case from the printer body.
③ Insert the clean filter case into the printer body.
Mount the clean filter in the correct position inside the case. If it is positioned incorrectly, the filter
performance will degrade and cause a malfunction of the ventilation fan.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Inclinometer
② Place the clean filter inside the case.
Position the clean filter carefully
(150616,En)
14 / 44