Table of Contents
Advertisement
Operation Gets Interrupted during Printing
● Check the power supply.
Problems in the Printout and the Operation Errors
Network Connection Can't Be Made between Cubicreator and the Device
●
Check the network settings of both Cubicreator and the device. Both must reside on the same
local network.
●
If the PC or the device is connected through wireless network, check whether the signal becomes
weak due to a long distance to the router.
●
The connection can be blocked by the security program or Windows firewall in the PC. Make an
adjustment on the related security program or firewall settings.
●
The network failure may occur according to the model of the wireless router.
A Sculpture Doesn't Get Adhered to the Base (Heating Bed) and It Gets
Taken Off.
●
Check whether it is a genuine filament. Some filaments don't adhere to the heating bed of our
company, which may cause a breakdown of the device during printing.
●
A filament that has been polluted by humidity or dusts may have different characteristics
compared to the characteristics at the time of the initial opening. The use of such filament may
cause a poor adherence to the heating bed. Use the filament as fast as possible once it is
opened, and if it needs to be stored, block the humidity and dusts using vinyl while fixing it to the
spool so that it doesn't get loosened, and then store it for only a short period of time.
●
Remove pollutants on the heating bed. Wet wipes that are available in the market may damage
the coating of the bed. Never use wet wipes on the heating bed. ( →
●
Check whether the temperature conditions of the heating bed and the Extruder are appropriate
for the filament used. The heating bed of Style Plus-A15 would be adhered well when the
temperature condition is appropriate for the filament used, and this temperature may vary
according to the type of the filament or the model, and the printing environment.
●
Check whether the area that adheres to the heating bed is too small or the base of a sculpture is
uneven. If the base support option is used during the creation of G-Code or the first layer printing
speed is slowed down, it can be improved.
●
If necessary, use an appropriate masking tape. In case of some molded models or filament types,
it may be helpful for the adherence of a sculpture to apply a separate heat-resisting tape such as
Kapton tape on the heating bed. Apply the tape in a way that the contacting point at the edge to
CUBICON Style Plus-A15 Series
67
U ser Manual
R efer to Bed Management
)
Advertisement
Table of Contents
