Turing On The Printer - Cubicon Style Plus-A15 Series User Manual

Turing on the Printer

1 Set the power switch on the side of the main body to
[​ O FF​ ] ​ position, ​ ( O)​ .
Before turning on the power, be sure to check following items once again.
1) Check whether there is any problem in the power connection including the twisting or folding of the
power cable and the connection to the power outlet.
​
; As for the power outlet, use only the independent single phase power at 220V 10A or higher with a
ground connection.
2) Check the mounting state/rotating direction/rotating state of the filament spool​ (Be cautious about the
rotating direction of the spool.)
3) Check whether it doesn't affect the movement of the Teflon tube.
4) Check the cable of the Extruder and the bed.
5) Check the mounting status of the Extruder module.
; Since fixing bolts of the extruder module may have been loosened during the transport, check the fixing state.
6) Check whether the heating bed is mounted at the accurate position.
; Since the position may have been shifted during the transportation, check the fixing state.
7) Check whether there is any damaged part.
3 Set the power switch on the side of the main body to
[ON] position, ​ ( ㅡ )​ .
* When pulling out a power cord or LAN cable, pull out by holding the connector instead of the cable.
* When the power is turned on, major parts related to the heating are automatically checked.
If an error appears in the info display area
of the error, and take a necessary action.
The printer may break down due to the damage of the electronic part as the cooling fan stops
Do not turn off the power of the printer while the extruder is heated.
CUBICON Style Plus-A15 Series​ ​
2 Insert the power cable in the power
input terminal at the lower part of the
rear of the main body, and plug in it
into a power outlet after organizing it
in a way that would not be tangled.
4 Check whether the LCD screen is
correctly displayed.
, go to the inspection screen, check the detail
operating.
22
U ser Manual