Test Model Printing; First Printing; Printing With Usb Memory - Cubicon Single Plus User Manual

* Sensor may not operate properly due to TPU ductility ,in the time of TPU printing. Make sure to
go to Setting > Function > Filament check OFF in prior to using ductile filament.
* Filament pieces, which come out by automatic unloading in the time of the filament passes through
the detection sensor, might be different depending on the printer model.
pieces might decrease as far as area gets wider and it makes pull out of filament pieces
impossible.
be needed.

8. Test model printing

This section explains from the installation to printing by using USB memory.
manual for method of printing through PC and USB cable connection.

8-1. First printing

① '7-1 Start loading after reading 'Loading' section.
8-2. Sample file of USB memory printing
① There is a sample file for printing in provided USB
memory.
Make sure to check remaining filament amount in prior to printing, as reprinting might
Direct printing
② Loading completion means printing preparation
completion.
② Select a file icon by pressing a print icon. Select
installed filament suitable clip.hfb file and print it out.
23
CUBICON Single Plus
The amount of filament
Refer to Cubicreator Software
User Manual