Accessories Included With Package - Cubicon Style 3DP-210F Quick Start Manual

Hide thumbs

Table of Contents

Tweezers (x1)

Used to remove foreign

substances, such as filament

residues

Scrapper (x1)

Used to separate the molded part

or remove foreign substances

from the heating bed

Antistatic brush (x1)

Used to remove the pollutants

such as the filament residues.

Nozzle pin ф=1.5mm (x1)

Used to clean inside of the nozzle

when the output quality has

deteriorated due to a polluted

nozzle.

Wrench 2mm (x1)

To unscrew the bolts of cable

fixing block when separating the

Extruder module.

Spool holder (x1)

Used to mount the filament spool

into the hole of rear printer.

* The filament spool and clean filter are not mounted in the printer, but are packaged separately.

* The type and specification of the accessories included in the part may be changed without

notice to enhance the product.

* Please use the Cubicon homepage or contact a distributor to purchase additional accessories.

Using an unauthorized filament or part may cause damage to the product. Any problem related

to the use of an unauthorized part will not be covered by the after-sales service. Always use

accessories supplied by Cubicon.

Please use the specified Adapter. It may cause the considerable damage on the printer when

using unspecified power supply to affect the injury or property loss.

This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without

prior notification or consent.

HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering.