Dodge 2001 Ram 1500 Owner's Manual page 1670

BR/BE
MANUAL - NV3500 (Continued)
Fig. 102 Inserting Shaft Into Lever Opening
1 - SHIFT SHAFT
Fig. 103 Shift Socket
1 - SHIFT SOCKET
2 - SHIFT SHAFT
CAUTION: Both shaft roll pins can be installed
when the shaft is 180° off. If this occurs, the trans-
mission will have to be disassembled again to cor-
rect shaft alignment.
(9) Select correct new roll pin for shift shaft lever
(Fig. 104). Shaft lever roll pin is approximately 22
mm (7/8 in.) long. Shift socket roll pin is approxi-
mately 33 mm (1-1/4 in.) long.
(10) Align roll pin holes in shift shaft, lever and
bushing. Then start roll pin into shaft lever by hand
(Fig. 105).
MANUAL - NV3500
Fig. 104 Roll Pin Identification
1 - SHAFT LEVER ROLL PIN
2 - SHIFT SOCKET ROLL PIN
Fig. 105 Roll Pin In Shift Socket
1 - SHAFT LEVER ROLL PIN
2 - LEVER AND BUSHING
(11) Seat shaft lever roll pin with pin punch (Fig.
106).
CAUTION: Shaft lever roll pin must be flush with
the surface of the lever. The lever bushing will bind
on the roll pin if the pin is not seated flush.
(12) Verify that lock pin slot in lever bushing is
positioned as shown (Fig. 106).
(13) Align roll pin holes in shift socket and shift
shaft. Then start roll pin into shift shaft by hand
(Fig. 107).
(14) Seat roll pin in shift socket with pin punch.
Roll pin must be flush with socket after installation
(Fig. 108).
(15) Verify that notches in shift fork arms are
aligned. Realign arms if necessary.
21 - 35