Usata Ssds; Removing A 1.8 Inch Usata Ssd Blank - Dell PowerEdge C4130 Owner's Manual

uSATA SSDs

The PowerEdge C4130 supports up to two 1.8 inch uSATA Solid State Drives (SSDs). The uSATA SSDs
connect to the system board through the hard drive backplane.
NOTE: Use only SSDs that have been tested and approved for use with the hard drive backplane.
When you format an SSD, allow enough time for the formatting to be completed. High-capacity SSDs
can take a number of hours to format.

Removing a 1.8 inch uSATA SSD blank

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
CAUTION: To maintain proper system cooling, all empty SSD slots must have SSD blanks
installed.
Steps
Press the release button and slide the SSD blank out of the SSD slot.
Figure 52. Removing a 1.8 inch SSD blank
1. SSD blank
Next steps
Install the 1.8 inch uSATA SSD carrier or SSD blank.
Related Links
Safety instructions
Installing a 1.8 inch uSATA SSD carrier
Installing a 1.8 inch uSATA SSD blank
2. release tab
129