Table of Contents
Advertisement
Figure 10. Removing the system top cover (back)
1.
system top cover (back)
Related Links
Safety instructions
Before working inside your system
Installing the system top cover (back)
Installing the system top cover (back)
Prerequisites
1.
Follow the safety guidelines listed in the safety instructions section.
2.
Ensure that all internal cables are connected and routed correctly.
3.
Keep the Phillips #1 screwdriver ready.
CAUTION: Closing the system cover with incorrect cable routing can damage the cables.
Steps
1.
Align the slots of the system top cover with the tabs on the chassis.
2.
Align the guide pin on the back of the chassis with the guide slot on the back of the cover.
3.
Slide the cover towards the front of the chassis until the guide pin on the back of the chassis locks on
the back of the cover.
4.
Secure the system top cover to the chassis by using the screws.
2.
screw (2)
63
Advertisement
Table of Contents
Troubleshooting
