System Battery; Replacing The System Battery - Dell PowerEdge C4130 Owner's Manual

2. Install the PCIe shroud
3. Follow the procedure listed in the After working inside your system section.
4. While booting, press F2 to enter System Setup and verify that the processor information matches the
new system configuration.
5. Run the system diagnostics to verify that the new processor operates correctly.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Installing a processor
Installing the cooling shroud
Installing the PCIe shroud
Removing a heat sink

System battery

The system board battery is used for low-level system functions like powering the real-time clock and
storing the computer's BIOS settings.
Related Links

Replacing the system battery

Replacing the system battery
Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. For more
information, see the safety information that shipped with your system.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Disconnect the GPU signal and power cables from the system board.
Steps
1. Locate the battery socket. For more information, see the System board jumpers and connectors
section.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
2. Place your finger between the securing tabs at the negative side of the battery connector and lift the
battery out of the socket.
97