Graphics Processing Unit - Dell PowerEdge C4130 Owner's Manual

CAUTION: Make sure the airflow arrows on the side of the fans are pointing to the rear of the
chassis. If the cooling fan is installed in reverse direction the system may overheat.
2. Align the cooling fan with the slot on the chassis and slide the fan into the slot.
3. Connect the cooling fan power cable to the cooling fan connector on the system board.
Figure 72. Installing cooling fan
1. cooling fan (8)
3. cooling fan connector on system board
Next steps
1. Install the system top cover (front).
2. Follow the procedure listed in after working inside your system.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Installing the system top cover (front)
Removing the system top cover (front)
Removing a cooling fan

Graphics processing unit

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
The following are the high-level steps that you must perform to replace the GPU:
154
2. cooling fan power cable
4. cooling fan slot