Dell PowerEdge C4130 Owner's Manual page 123

About this task
CAUTION: To maintain proper system cooling, a minimum of two hard drives must be installed in
hard drive 0/E and 1/F slots.
Steps
1. Remove the screws securing the hard drive to the hard drive cage.
2. Remove hard drives 0/E and 1/F by performing the following steps:
a. Disconnect the signal/power cable from the hard drives.
b. Lift hard drive 0/E out of the hard drive cage.
c. Slide hard drive 1/F out of the hard drive cage.
Figure 46. Removing a 2.5 inch cabled hard drive (hard drive 0/E and hard drive 1/F) from the hard drive
cage
1. hard drive 1/F
3. power and signal cable connector on
hard drive
5. screw (8)
3. If you want to remove hard drives 2/C and 3/D, perform the following steps:
a. Remove hard drives 0/E and 1/F.
b. Disconnect the signal/power cables from hard drive 2/C and 3/D.
c. Remove the signal/power cables routed through the cable clip on the hard drive cage.
d. Lift hard drive 2/C out of the hard drive cage.
e. Slide hard drive 3/D out of the hard drive cage.
2. power and signal cable connector (2)
4. hard drive 0/E
6. hard drive cage
123