System Board; Removing The System Board - Dell PowerEdge C4130 Owner's Manual

Figure 65. Installing the cable routing clip
1. cable routing clip
3. screw hole on the system board (2)
Next steps
1. Connect and route the cables through the cable routing clip.
2. Follow the procedure listed in after working inside your system.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Removing the cable routing clip

System board

Removing the system board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may
be prompted to create a recovery key during program or System Setup. Be sure to create and
safely store this recovery key. If you replace this system board, you must supply the recovery key
when you restart your system or program before you can access the encrypted data on your hard
drives.
142
2. screw (2)