After Working Inside Your System; Recommended Tools; System Covers; Removing The System Top Cover (Front) - Dell PowerEdge C4130 Owner's Manual

Removing the system top cover (front)

Removing the system top cover (back)

After working inside your system

Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Install the system cover.
2. If applicable, install the system into the rack.
For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.
3. Reconnect the peripherals and connect the system to the electrical outlet.
4. Turn on the system, including any attached peripherals.
Related Links
Installing the system top cover (front)
Installing the system top cover (back)

Recommended tools

You need the following tools to perform the removal and installation procedures:
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• #T6 and #T10 Torx screwdrivers
• Wrist grounding strap

System covers

The system cover protects the innards of the server and helps in maintaining air flow inside the server.
Removing the system cover actuates the intrusion switch and aids in maintaining system security.
Related Links
Removing the system top cover (front)
Installing the system top cover (front)
Removing the system top cover (back)
Installing the system top cover (back)
Removing the system top cover (front)
Prerequisites
CAUTION: Do not operate the system without the system cover. This can result in overheating
and cause component damage.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
60