Dell PowerEdge C4130 Owner's Manual page 106

Steps
1. Align the expansion card riser with the guide pin on the system board and the guide slot on the
chassis.
2. Lower the expansion card riser and press it until it clicks into place.
Figure 33. Installing the expansion card riser
1. touch point (4)
3. expansion card clip
5. riser connector on the system board
7. guide pin on the system board
CAUTION: The expansion card riser should be installed in the system before you install the
expansion card riser cables to prevent pin damage in the PCIe connectors on the system
board.
Next steps
1. If applicable, connect the riser cables to the system board.
2. Install the PCIe shroud.
3. Follow the procedure listed in the After working inside your system section.
4. Install any device drivers required for the expansion card. For more information, see the
documentation for the card.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Installing the PCIe shroud
Removing the PCIe shroud
106
2. expansion card riser
4. guide slot on the chassis
6. guide post on the expansion card riser