Connecting The Modem To The Console Port On The Srx550 High Memory Services Gateway; Connecting To The Srx550 High Memory Services Gateway From The Cli With The Usb Console Port; Figure 23: Console Cable Connector - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide
Connecting the Modem to the Console Port on the SRX550 High Memory Services
Gateway
Related
Documentation
Connecting to the SRX550 High Memory Services Gateway from the CLI with the USB
Console Port
110
To connect the dial-up modem to the console port on the SRX550 High Memory Services
Gateway:
Turn off power to the services gateway.
1.
Turn off power to the modem.
2.
Plug one end of the Ethernet cable into the console port on the services gateway.
3.
(Figure 23 on page 110 shows the console cable connector).

Figure 23: Console Cable Connector

Plug the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter.
4.
NOTE: Most modems have an RS-232 DB-25 connector. You must
separately purchase an adapter to connect your modem to the RJ-45 to
DB-9 adapter and Ethernet cable.
Connect the serial port adapter to a separately purchased DB-9 female to DB-25
5.
male adapter or other adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
6.
Connect the modem to your telephone network.
7.
Turn on the power to the modem.
8.
Power on the services gateway by pressing the Power button on the front of the
9.
services gateway. Verify that the POWER LED on the front panel turns green.
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
Configuring the Modem at the SRX550 High Memory Services Gateway End on page 113
Connecting the CLI at the User End for the SRX550 High Memory Services Gateway
on page 112
You can connect your management device to the USB console port on the services
gateway and use the CLI to configure the services gateway, as shown in
Figure 24 on page 111.
Copyright © 2016, Juniper Networks, Inc.