Installing A Gigabit-Backplane Physical Interface Module - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide

Installing a Gigabit-Backplane Physical Interface Module

176
Label the cables connected to the GPIM so that you can later reconnect each cable
3.
to the correct GPIM.
Disconnect the cables from the GPIM.
4.
If necessary, arrange the cables to prevent them from dislodging or developing stress
5.
points.
Using a Phillips (+) screwdriver, loosen the captive screws on each side of the GPIM
6.
faceplate.
Grasp the handles on each side of the GPIM faceplate, and slide the GPIM out of the
7.
services gateway.
Place the GPIM in an electrostatic bag or on an antistatic mat.
8.
If you are not reinstalling a GPIM into an empty slot, install a blank GPIM faceplate in
9.
the empty slot to maintain proper airflow.
NOTE: When installing a blank GPIM faceplate, make sure that the padded
side of the faceplate is facing up.
Before you begin:
Ensure that the services gateway is powered off.
Ensure that the GPIM is installed in the appropriate GPIM slot.
NOTE: To maintain proper airflow through the services gateway, leave blank
faceplates in place over slots that do not contain GPIMs. Do not remove a
blank faceplate unless you are immediately installing a GPIM in the empty
slot.
To install a GPIM:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the handles on each side of the GPIM faceplate, and align the edges of the
2.
GPIM circuit board with the guide rails at each side of the GPIM slot.
Slide the GPIM into the services gateway until it seats firmly in the device.
3.
CAUTION: Slide the GPIM straight into the slot to avoid damaging the
components on the GPIM.
Using a Phillips (+) screwdriver, tighten the captive screws on each side of the GPIM
4.
faceplate.
Copyright © 2016, Juniper Networks, Inc.