Remotely - Juniper SRX550 Hardware Manual

Related
Documentation
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely
Related
Documentation
Copyright © 2016, Juniper Networks, Inc.
Table 57: Port Settings (continued)
Port Settings
Data bits
Parity
Stop bits
Flow control
Power on the services gateway by pressing the Power button on the front of the
9.
services gateway. Verify that the POWER LED on the front panel turns green.
The terminal emulation screen on your management device displays the startup
sequence. When the services gateway has finished starting up, a login prompt appears.
Log in as the user . No password is required at initial connection, but you must
10. root
assign a root password before committing any configuration settings.
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
You can connect an SRX550 High Memory Services Gateway to the CLI from a remote
location through two dial-up modems:
A modem that is connected to the console port on the services gateway
A second modem that is connected to a remote management device
The modem connection lets you remotely perform the same console operations that
you can perform locally.
Configuring the Modem at the SRX550 High Memory Services Gateway End on page 113
Connecting the Modem to the Console Port on the SRX550 High Memory Services
Gateway on page 110
Connecting the CLI at the User End for the SRX550 High Memory Services Gateway
on page 112
Chapter 18: Performing Initial Configuration
Value
8
None
1
None
133