Configuring Mini-Physical Interface Modules; Using The J-Web Interface - Juniper SRX550 Hardware Manual

Related
Documentation

Configuring Mini-Physical Interface Modules

Using the J-Web Interface

Copyright © 2016, Juniper Networks, Inc.
[edit]
user@host# set security zones security-zone trust interfaces ge-0/0/x.0
host-inbound-traffic system-services all
where x is less than or equal to 16
Add or select security zones for host inbound traffic protocol options:
6.
[edit]
user@host# set security zones security-zone trust interfaces ge-0/0/x.0
host-inbound-traffic protocols all
where x is less than or equal to 16
Set security policies:
7.
[edit]
user@host# set security policies default-policy permit-all
SRX550 High Memory Services Gateway Gigabit-Backplane Physical Interface Modules
Overview on page 23
8-Port Gigabit Ethernet SFP XPIM on page 25
16-Port Gigabit Ethernet XPIM (PoE) on page 29
To enable the Mini-Physical Interface Module (Mini-PIM) installed on the services gateway,
you must configure the basic settings for the Mini-PIM. You can perform the configuration
tasks for this using either the J-Web interface or the CLI.
Using the J-Web Interface on page 137
Using the CLI on page 138
To perform basic configuration for the Mini-PIM and to configure network interfaces for
the services gateway using the J-Web interface:
In the J-Web interface, select
1.
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
Select the interface name and click
2.
click OK . To use the port on the Mini-PIM, assign an IP address to the port and assign
it to a security zone, other than the Null zone. If there are no security zones listed,
proceed to the next step to add a security zone.
Chapter 18: Performing Initial Configuration
Configure>Interfaces .
Add > Logical Interfaces
. Enter the details and
137