Using The Cli - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide

Using the CLI

138
Add a security zone to the interface:
3.
Select
Configure>Security>Zones/Screens
a.
Add or select a security zone other than Null; for example,
b.
to the zone.
For Host Inbound Traffic-Zone, set the following:
c.
System Services=
Protocols=
Allow All
Click OK to save changes, and select
d.
and other pending changes (if any).
To use the port on the Mini-PIM, you must also set security policies. Select the following
4.
settings:
Select
Configure>Security>Security Policy
a.
Select
b. Global Options > Policy Options
Set Policy Option: Default Policy Action=
c.
Click to save changes, and select
d. OK
and other pending changes (if any).
To perform basic configuration for Mini-PIM and to configure network interfaces for the
services gateway using the CLI:
Verify that the Mini-PIM is installed on the device:
1.
show chassis hardware
Verify the status of the interface:
2.
show interfaces terse
Assign the port an IP address:
3.
For T1 interfaces:
set interfaces t1-1/0/0 unit 0 family inet address interface address/destination prefix
For E1 interfaces:
set interfaces e1-1/0/0 unit 0 family inet address interface address/destination prefix
For the 1-Port Serial Mini-PIM:
set interfaces se-1/0/0 unit 0 family inet address interface address/destination prefix
Add or select a security zone; for example, Trust:
4.
For T1 interfaces:
.
Allow All
Commit>Commit
.
.
Permit-All
Commit>Commit
Trust . Assign the interface
to apply the configuration
.
to apply the configuration
Copyright © 2016, Juniper Networks, Inc.