Faceplate - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide
Installing a Blank Gigabit-Backplane Physical Interface Module Faceplate
Related
Documentation
178
To maintain proper airflow through the services gateway, install blank faceplates in slots
that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs).
To install a blank faceplate:
Align the captive screws on the blank faceplate with the screw holes on the chassis.
1.
Using a Phillips (+) screwdriver, tighten the captive screws on each side of the blank
2.
faceplate until the faceplate is flush with the chassis.
Replacing Mini-Physical Interface Modules on the SRX550 High Memory Services
Gateway on page 171
Copyright © 2016, Juniper Networks, Inc.