Replacing Mini-Physical Interface Modules; Gateway; Removing A Mini-Physical Interface Module - Juniper SRX550 Hardware Manual

CHAPTER 23

Replacing Mini-Physical Interface Modules

Replacing Mini-Physical Interface Modules on the SRX550 High Memory Services

Gateway

Removing a Mini-Physical Interface Module

Copyright © 2016, Juniper Networks, Inc.
Replacing Mini-Physical Interface Modules on the SRX550 High Memory Services
Gateway on page 171
Before you begin, power off the services gateway.
CAUTION: The Mini-Physical Interface Modules (Mini-PIMs) available are
not hot-swappable. You must power off the services gateway before removing
or installing Mini-PIMs.
To maintain proper airflow through the services gateway, cover any empty Mini-PIM slot
with a blank faceplate.
CAUTION: Do not remove a blank faceplate unless you are installing a
Mini-PIM in the empty slot.
Removing a Mini-Physical Interface Module on page 171
Installing a Mini-Physical Interface Module on page 172
Removing a Blank Mini-Physical Interface Module Faceplate on page 173
Installing a Blank Mini-Physical Interface Module Faceplate on page 173
To remove a Mini-PIM from the services gateway:
Place an electrostatic bag or antistatic mat on a flat, stable surface on which you
1.
intend to place the Mini-PIM.
Attach an ESD grounding strap to your bare wrist, and connect the strap to the
2.
grounding point on the back of the device.
Unplug the power adapter from the services gateway. Verify that the Power LED is
3.
off.
171