Connecting The Modem To The Console Port On The Srx100 Services Gateway - Juniper SRX100 Hardware Manual

Table 22: Port Settings to Configure the Modem on Services Gateway End (continued)
Port Settings
Parity
Stop bits
Flow control
5.
6.
7.
8.
9.
Related Topics

Connecting the Modem to the Console Port on the SRX100 Services Gateway

To connect the dial-up modem to the console port on the services gateway:
1.
2.
3.
4.
5.
6.
Chapter 12: Establishing Basic Connectivity for the SRX100 Services Gateway
In the HyperTerminal window, enter
For more information on the AT commands, see the JUNOS Software
Administration Guide.
An OK response verifies that the modem can communicate successfully with the
port on the PC or laptop.
COM
To configure the modem to answer a call on the first ring, enter
To configure the modem to accept modem control DTR signals, enter
To disable flow control, enter
To save modem settings, enter
Connecting the Modem to the Console Port on the SRX100 Services Gateway on
page 65
Connecting to the CLI at the User End for the SRX100 Services Gateway on page
66
Connecting an SRX100 Services Gateway to the CLI Locally on page 62
Connecting an SRX100 Services Gateway to the CLI Remotely on page 64
Connecting an SRX100 Services Gateway to the J-Web Interface on page 60
Turn off power to the services gateway.
Turn off power to the modem.
Plug one end of the Ethernet cable supplied with your services gateway into the
console port (Figure 18 on page 121 shows the console cable connector) on the
services gateway.
Plug the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter
supplied with your services gateway.
Connect the serial port adapter to a separately purchased DB-9 female to DB-25
male adapter or other adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
Connecting the Modem to the Console Port on the SRX100 Services Gateway
Value
None
1
None
AT .
AT&K0 .
.
AT&W
ATS0=1 .
.
AT&D1
65