Gateway; Table 60: Power Led Description - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide
Troubleshooting the Power System on the SRX550 High Memory Services Gateway
150
Changing the RESET CONFIG Button Behavior on the SRX550 High Memory Services
Gateway on page 154
The LEDs on the services gateway enable you to determine the performance and operation
of the power system. The POWER LED located on the front panel of the services gateway,
as described in Table 60 on page
to the power system. The LEDs on the faceplate of each power supply also show power
supply status as described in

Table 60: POWER LED Description

LED Status LED State
Green On
Red On
Amber On
150, indicates the different status settings with respect
Table 61 on page 152.
Meaning
The services gateway
is receiving power,
and all power supply
units (PSUs) are
working properly.
Indicates failure of
one or more PSUs.
Power button has
been pressed. The
services gateway will
shut down.
Copyright © 2016, Juniper Networks, Inc.
Possible Cause and Corrective
Action
Normal indication. No action is
required.
If you cannot determine the cause
of the problem or need additional
assistance while troubleshooting
a services gateway, open a support
case using the Case Manager link
at
http://www.juniper.net/support/
or call 1-888-314-JTAC (within the
United States) or 1-408-745-9500
(outside the United States).
Once the services gateway is
running again, continue
troubleshooting.
,