Figure 28: Connecting To The Console Port On The Srx550 High Memory Services; Table 57: Port Settings - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide
132
Figure 28: Connecting to the Console Port on the SRX550 High Memory
Services Gateway
NOTE: Figure 28 on page 132
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (RJ-45 to a DB-9 serial port adapter),
along with an adapter for your modem, which you must purchase separately.
To connect to the CLI using a local management device through the console port on the
services gateway:
Turn off power to the services gateway.
1.
Turn off power to the management device (such as a desktop or laptop computer)
2.
that you are using to access the CLI.
Plug one end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter (see
3.
Figure 28 on page 132).
Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
4.
device (see Figure 28 on page
Connect the other end of the Ethernet cable to the console port on the services
5.
gateway (see Figure 28 on page
Turn on the power to the management device.
6.
Start your asynchronous terminal emulation application (such as Microsoft Windows
7.
HyperTerminal), and select the appropriate
Configure the port settings, as shown in
8.

Table 57: Port Settings

Port Settings
Bits per second
shows a connection to a local management
132).
132).
port to use (for example,
COM
Table 57 on page
Value
9600
Copyright © 2016, Juniper Networks, Inc.
).
COM1
132.