Juniper SRX550 Hardware Manual page 38

SRX550 High Memory Services Gateway Hardware Guide
Table 6: SRX550 High Memory Services Gateway Front Panel Components (continued)
Number Component
9 6 fixed Gigabit Ethernet
ports:
Port labeled 0/0
Port labeled 0/1
Port labeled 0/2
Port labeled 0/3
Port labeled 0/4
Port labeled 0/5
Provides link speeds of
10/100/1000 Mbps.
10 RESET CONFIG Button
11 Power button
12 USB 0 and USB 1 ports
16
Location Description
Left side of the The Gigabit Ethernet ports have the following characteristics:
front chassis panel,
Use an RJ-45 connector.
lower edge
Operate in full-duplex and half-duplex modes.
Support flow control.
Support autonegotiation.
The Gigabit Ethernet ports can:
Function as front-end network ports.
Provide LAN and WAN connectivity to hubs, switches, local
servers, and workstations.
Forward incoming data packets to the services gateway.
Receive outgoing data packets from the services gateway.
Left side of the Returns the services gateway to the rescue configuration or
front chassis panel the factory default configuration. For more information, see
"Resetting the SRX550 High Memory Services Gateway" on
page 154.
Left side of the Use the Power button to shut down the services gateway.
front chassis panel
On a services gateway that has been previously shut down
using the Power button, the services gateway starts up when
the power button is pressed again.
WARNING:
power supplies or the midplane. You must remove the power
cables or power cords to completely shut down the services
gateway. The DC OK LED light on the power supply unit (PSU)
changes from green to amber indicating that the software has
stopped running. After the software has stopped running, you
can safely remove any GPIMs or Mini-PIMs from the services
gateway.
Left side of the The services gateway has two USB ports, labeled USB 0 and
front chassis panel USB 1, that accept a USB storage device. These USB ports
accept USB flash drives with Type A plugs. When the USB
drive is installed and configured, it automatically acts as the
secondary boot device if the primary CompactFlash card fails
on startup.
NOTE:
to use it as the secondary boot device. The services gateway
supports the following USB devices:
Lexar 2 GB
Juniper Networks 2 GB
Depending on the capacity of the USB drive, you can also
configure it to receive core files generated during a failure.
The Power button does not shut off power to the
You must install Junos OS on the USB storage device
Copyright © 2016, Juniper Networks, Inc.