Port 10-Gigabit Ethernet/Gigabit Ethernet Line Card With Sfp+ Or Sfp - Cisco ASR 9000 Series Installation Manual

Overview
3 Port 0 SFP+ cage
4 Port 11 SFP+ cage

24-Port 10-Gigabit Ethernet/Gigabit Ethernet Line Card with SFP+ or SFP

Note Oversubscription will be supported on this line card in a future release of IOS XR 6.2.x train.
The 24-Port 10-Gigabit Ethernet (10GE)/Gigabit Ethernet (GE) line card has twenty-four dual-rate ports that
accept 10GE SFP+ or 1GE SFP modules.
Note
The 24-port line card has a single Network Processor Unit (NPU). Configuring more than 20x10GE ports per
NPU could result in line drops across all ports, depending on the packet size and traffic type. See
the Dual-Rate Line Cards
The 24-Port 10GE/1GE line card is available in these variants:
• -SE (Service Edge Optimized)
• -TR (Packet Transport Optimized)
• -CM (Consumption Model)
The -SE and -TR variants are functionally equivalent, but vary in configuration scale and buffer capacity. The
-CM variant is same as the -SE variant except that the -CM variant functions on Consumption Based Pricing
Model supported with Smart Licensing. For details related to the Consumption Based Pricing Model, see the
chapter Software Entitlement in the Cisco ASR 9000 Series Aggregation Services Router System Management
Configuration Guide.
Each SFP+ cage on the 24-Port 10GE/1GE line card has an adjacent Link LED visible on the front panel. The
Link LED indicates the status of the associated SFP+ port, as described in
The following figure shows the 24-Port 10GE/1GE line card front panel connectors and indicators.
24-Port 10-Gigabit Ethernet/Gigabit Ethernet Line Card with SFP+ or SFP
7 Line card status LED
for information on specifying the port speed.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Configuring
Line Card LEDs, on page 138.
29