Use Of The Capacity Chart; Capacity Indicator Locations - JLG G5-18A Operation Manual

5.5

USE OF THE CAPACITY CHART

To properly use the capacity chart (see page 5-6), the operator must first determine and/
or have the following:
1. An approved attachment. See "Approved Attachments" on page 5-1.
2. The proper Capacity Chart(s).
3. Weight of the load being lifted.
4. Load placement information:
a. HEIGHT where the load is to be placed.
b. DISTANCE from the front tires of the telehandler to where the load is to be placed.
5. On the capacity chart, find the line for the height and follow it over to the distance.
6. The number in the load zone where the two cross is the maximum capacity for this
lift. If the two cross at a division between zones, the smaller number must be used.
The number in the load zone must be equal to or greater than the weight of the load to be
lifted. Determine the limits of the load zone on the capacity chart and keep within these
limits.

Capacity Indicator Locations

ATTACHMENT
IDENTIFICATION
PLATE
FORK
WEIGHT
STAMP
31200743
BOOM EXTENSION
INDICATOR
A B
Section 5 - Attachments and Hitches
BOOM ANGLE
INDICATOR
OAL1730
5-5