Tires - JLG G5-18A Operation Manual

Section 7 - Lubrication and Maintenance

Tires

A. Tire Air Pressure Check
1. Perform "Shut-Down Procedure" on page 4-4.
2. Remove valve stem cap.
3. Check tire pressure.
4. Add air if required. See page 9-5 for tire pressures.
5. Replace valve stem cap.
B. Tire Damage
For pneumatic tires, when any cut, rip or tear is discovered that exposes sidewall or tread
area cords in the tire, measures be taken to remove the product from service immediately.
Arrangements must be made for replacement of the tire or tire assembly.
For polyurethane foam filled tires, when any of the following are discovered, measures
must be taken to remove the product from service immediately. Arrangements must be
made for replacement of the tire or tire assembly.
• A smooth even cut through the cord piles which exceeds 3 in (7,5 cm) in total length.
• Any tears or rips (ragged edges) in the cord plies which exceeds 1 in (2,5 cm) in any
direction
• Any punctures which exceed 1 in (2,5 cm) in diameter.
If a tire is damaged but within the above noted criteria, the tire must be inspected daily to
ensure the damage has not propagated beyond the allowable criteria.
C. Tire Wheel Replacement
It is recommended that a replacement tire to be the same size, ply and brand as originally
installed. Refer to the appropriate parts manual for ordering information. If not using an
approved replacement tire, replacement tires must have the following characteristics:
• Equal or greater ply/load rating and size of original.
• Tire tread contact width equal or greater than original.
• Wheel diameter, width and offset dimensions equal to the original.
• Approved for application by tire manufacturer (including inflation pressure and
maximum tire load).
Due to size variations between tire brands, when selecting and installing a replacement
tire ensure both tires on the axle are the same.
7-12
10
OW0970
31200743
OW1040