Fork Mounted Hook (Ansi & Ce) - JLG G5-18A Operation Manual

Fork Mounted Hook (ANSI & CE)
OY0640
Suspend loads in accordance with requirements set forth in Section 1- General
Safety Practices.
The joystick (1) controls lift/lower and the extend/retract movement of the boom.
The tilt button (2) enables fork mounted hook tilt.
• While pressing and holding button move joystick left to tilt up.
• While pressing and holding button move joystick right to tilt down.
Installation Procedure:
• Ensure carriage is properly installed. Refer to "Attachment Installation" on page 5-9.
• Secure the fork mounted hook to the forks by sliding the fork mounted hook onto the
parent forks and install the retaining pin behind the vertical shank of the fork.
Operation:
• Pallet or lumber forks of an appropriate load rating must be used. Do not use with
cubing or block forks.
• Weight of fork mounted hook and rigging must be included as part of total load being
lifted.
• Do not use fork mounted hook with attachments capable of rotating (i.e. side tilt and
swing carriages) without disabling the rotation features.
31200743
Use Appropriate Carriage Capacity Chart
To determine maximum capacity, refer to "Telehandler/Attachment/
Fork Capacity" on page 5-4.
1
Section 5 - Attachments and Hitches
2
OAL1961
5-19