Section 5 - Attachments And Hitches; Approved Attachments; Unapproved Attachments - JLG G5-18A Operation Manual

SECTION 5 - ATTACHMENTS AND HITCHES

5.1

APPROVED ATTACHMENTS

To determine if an attachment is approved for use on the specific telehandler you are
using, perform the following prior to installation.
• The attachment type, weight, dimensions and load center must be equal to or less
than the data shown on a capacity chart located in the operator cab.
• The model on the capacity chart must match the model telehandler being used.
• Hydraulically powered attachments must only be used on machines equipped with
auxiliary hydraulics.
• Hydraulically powered attachments that require auxiliary electrics must only be used
on machines equipped with auxiliary hydraulics and electrics.
If any of the above conditions are not met, do not use the attachment. The telehandler
may not be equipped with the proper capacity chart or the attachment may not be
approved for the model telehandler being used. Contact JLG or the local distributor for
further information.
5.2

UNAPPROVED ATTACHMENTS

Do not use unapproved attachments for the following reasons:
• Range and capacity limitations for "will fit, " homemade, altered, or other
non-approved attachments cannot be established.
• An overextended or overloaded telehandler can tip over with little or no warning and
cause serious injury or death to the operator and/or those working nearby.
• The ability of a non-approved attachment to perform its intended function safely
cannot be assured.
Use only approved attachments. Attachments which have not been approved for use
with your telehandler could cause machine damage or an accident.
31200743
Section 5 - Attachments and Hitches
WARNING
5-1