Sample Capacity Chart (Aus) - JLG G5-18A Operation Manual

Sample Capacity Chart (AUS)

Traveling Boom
Information Angle
X° MAX
TRAVELING (PICK & CARRY)
REQUIRES FIRM SURFACE WITH LOAD ON FORKS.
MAX TRAVEL SPEED XXKM/H. BOOM FULLY RETRACTED.
LIFTING (STATIONARY)
REQUIRES FIRM SURFACE WITH LOAD ON FORKS.
X° MAX
SPECIFICATIONS FOR SAFE USE
1. TIRE SIZES: (XX XX, XXXXX)
2. TIRE PRESSURE: (XXXX XX)
3. IN-SERVICE WIND SPEED: (XXM/S, XXKM/H)
4. GROUND CONDITIONS:
- FIRM SURFACES FOR BOTH LIFTING
AND TRAVELING.
- SLOPE AND LOAD LISTED ABOVE FOR
BOTH CONFIGURATIONS.
5. STANDARD USED: (XX XXXXXXXX).
Lifting
Information
Note: This is a sample capacity chart only! DO NOT use this chart, use the one located in your
operator cab.
TIP OVER HAZARD. All loads shown on rated capacity chart are based on machine
being on firm ground with frame level (see page 4-6); the forks being positioned
evenly on carriage; the load being centered on forks; proper size tires being properly
inflated; and the telehandler being in good operating condition.
31200743
Quick Attach Type
Blank = Standard
Quick Attach
UQC = Universal Quick
Attach
XXXMM MAX
X° MAX
XXXMM
MAX
X° MAX
X° MAX
X° MAX
XXXXXXXXXX
Specifications For
Safe Use
WARNING
Section 5 - Attachments and Hitches
This Capacity Chart may be
used with this model ONLY.
The telehandler model is
indicated on the boom or
chassis. Model XXXX is used
for demonstration purposes
only.
XXXX
XXX
XX
XX
XXXMM MAX
XX
XX
XX 40°
XX
30°
XX
20°
XX
XX
10°
XX
0°
X
XX XX XX XX XX XX XX
XXXX XXXX
Load zones indicate
the maximum
weight that may be
safely lifted.
Attachment type,
weight and
dimensions must be
equal to or less than
the data shown.
XX
+
= XXX XX MAX
70°
E
60°
D
C
50°
B
A
XX
Load center must Boom Extension
be equal to or Indicator (arc)
less than value
shown.
1
OAL2150
5-7