Removing An Uplink Module From An Ex3200 Switch; Figure 52: Installing An Uplink Module In An Ex3200 Switch - Juniper EX3200 Hardware Manual

Related
Documentation

Removing an Uplink Module from an EX3200 Switch

Copyright © 2016, Juniper Networks, Inc.

Figure 52: Installing an Uplink Module in an EX3200 Switch

NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing an Uplink Module from an EX3200 Switch on page 197
Installing a Transceiver on page 201
Installing and Removing EX3200 Switch Hardware Components on page 152
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Front Panel of an EX3200 Switch on page 9
If your EX3200 switch includes an optional uplink module, it is installed in the switch's
front panel. The different types of uplink modules are described in
EX3200 Switches" on page
The uplink module in EX3200 switches is a hot-removable and hot-insertable unit (FRU):
You can remove and replace it without powering off the switch or disrupting switch
functions.
Before you begin removing an uplink module from the switch:
Ensure that you have taken the necessary precautions to prevent ESD damage (see
"Prevention of Electrostatic Discharge Damage" on page
If there are any transceivers installed in the uplink module, remove them before you
remove the uplink module. For instructions on removing transceivers, see
a Transceiver" on page 203.
15.
Chapter 17: Replacing Uplink Module
. Failure
"Uplink Modules in
269).
"Removing
197