Installing And Removing Ex3200 Switch Hardware Components; Figure 32: Mounting The Switch On A Wall - Juniper EX3200 Hardware Manual

EX3200 Switch Hardware Guide
Related
Documentation

Installing and Removing EX3200 Switch Hardware Components

152
If the mounting screws are inserted in wall board with no stud behind it, you must use
dry wall anchors rated to support 75 lb (34 kg). Insert the screws into wall studs
wherever possible to provide added support for the chassis.
Screw the screws only part way in, leaving about 1/4 in. (6 mm) distance between
the head of the screw and the wall.
Grasp each side of the switch or switches, lift the switch or switches, and hang the
4.
brackets from the mounting screws as shown in

Figure 32: Mounting the Switch on a Wall

Rear panel
Hang attached brackets
on wall-mounted screws.
Tighten the mounting screws.
5.
Connecting AC Power to an EX3200 Switch on page 161
Connecting DC Power to an EX3200 Switch on page 163
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 175
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 178
Wall-Mounting Warning for EX3200 Switches on page 252
The EX3200 switch chassis is a rigid sheet-metal structure that houses the hardware
components. The field-replaceable units (FRUs) in EX3200 switches are:
Power supply
Fan tray
Uplink module
SFP transceiver
SFP+ transceiver
XFP transceiver
Figure 32 on page 152.
Front
panel
Copyright © 2016, Juniper Networks, Inc.