Wheels And Tires - Arctic Cat DVX 400 2008 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
9. Connect the tie rod ends (11) to the steering
knuckle (12) making sure that the washer (10) is
properly located; then tighten the nut to specifica-
tions and install a new cotter pin.
NOTE: During assembly, new cotter pins should
be installed.
www.mymowerparts.com
Back
7-16
SP393
SP394
ATV2197
Back to TOC

Wheels and Tires

TIRE SIZE
! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable ATV
operation.
The ATV is equipped with low-pressure tubeless tires
of the size and type listed in Section 1. Do not under
any circumstances substitute tires of a different type or
size.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the ATV and could
cause excessive drive train damage not covered by
warranty.
TIRE INFLATION PRESSURE
Tire inflation pressure should be 0.30 kg/cm² (4.4 psi)
front and 0.275 kg/cm² (4.0 psi) rear.
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove the wheels.
NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and
leaks.
INSTALLING
1. Install each wheel on its hub.
Back to Section TOC
Next