Valve/Tappet Clearance - Arctic Cat DVX 400 2008 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
INSTALLING
KEY
1. Air Cleaner Assy
2. Filter
3. Holder
4. Stopper
5. Screw
6. Outlet Tube
7. Elbow Fitting
8. Breather Plug
9. Clip
10. Clamp
11. Clamp
12. Flame Trap
13. Cover
14. Gasket
15. Inlet Joint
16. Inlet Duct
17. Clamp
18. Cap Screw
19. Cap Screw
1. Place the air cleaner into the frame.
2. Install the cap screws securing the air cleaner to
the frame.
3. Install the outlet tube onto the air cleaner; then
tighten the clamp securely.
4. Install the inlet duct onto the air cleaner; then
tighten the clamp securely.
5. Install the filter with foam wrap into the air
cleaner; then tighten the filter stopper screw
securely.
6. Place the air cleaner cover into position and secure
with the retaining clips.
www.mymowerparts.com
Back
2-6
0739-212
SP012
Back to TOC
7. Install the seat making sure the seat is properly
secured.

Valve/Tappet Clearance

CHECKING
To check and adjust valve/tappet clearance, use the
following procedure.
1. Remove the seat, gas tank cover, and body.
2. Turn the fuel valve to the ON position; then
remove the gas tank.
3. Disconnect the engine oil hose (3) and the engine
oil breather hose (4); then remove the spark plug.
4. Remove the three large Allen-head cap screws
securing the valve cover; then remove the valve
cover accounting for the two camshaft end plugs
and the valve cover gasket.
Back to Section TOC
SP014A
SP120
Next