Arctic Cat DVX 400 2008 Service Manual page 118

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
10. Using a ball joint remover (8), remove the ball
joint from the knuckle (7).
CLEANING AND INSPECTING
1. Clean the knuckle in parts-cleaning solvent; then
dry with compressed air. If any damage or exces-
sive wear is detected, the knuckle must be
replaced.
2. Inspect the ball joint for boot damage or wear.
Remove the circlip and replace the ball joint if
damage is found.
www.mymowerparts.com
Back
SP374
SP375
SP376
Back to TOC
3. Inspect the arm for broken welds, cracks, or bends.
Replace if damaged.
4. Remove the spacers and dust seals and inspect for
damage to seal lips and spacers.
NOTE: The pivots are equipped with roller bear-
ings. The bearing rollers may fall out when the
spacers are removed.
Back to Section TOC
SP377
SP378
7
SP379
Next
7-13