Wheels And Tires - Arctic Cat 650 Twin2004 Service Manual

Wheels and Tires

KEY
1. Machine Screw
2. Brake Disc
3. Wheel Hub - Front
4. Hub Stud
5. Hub Seal
6. Castle Nut
7. Cotter Pin
8. Wheel
9. Tire - Front
10. Mounting Nut
11. Valve Stem
12. Valve Stem Cap
13. Wheel Hub - Rear
14. Wheel
15. Tire - Rear
TIRE SIZE
! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable ATV
operation.
The ATV is equipped with low-pressure tubeless tires
of the size and type listed below. Do not under any cir-
cumstances substitute tires of a different type or size.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning
could cause poor handling qualities of the ATV and
could cause excessive drive train damage not cov-
ered by warranty.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.35
kg/cm² (5.0 psi).
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove the wheels.

NOTE: Keep left-side and right-side wheels sep-
arated for installing them on their proper sides.
0739-058
7
CD006
7-9