Arctic Cat DVX 400 2008 Service Manual page 131

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
8. Lift the body clear of all brackets and studs; then
rotate clockwise and work handlebar through the
center body openings.
9. Set body and tank panel to the side in a safe place.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all body components with soap and water.
2. Inspect the body and fenders for cracks.
3. Inspect threaded areas of all mounting studs for
stripping.
4. Inspect for missing decals.
INSTALLING
1. Fit the body over the handlebar and rotate into nor-
mal mounting position.
2. Seat the two upper forward support studs and the
rear fender support studs into the brackets; then
install the nuts and tighten securely. Take care not
to over-tighten.
www.mymowerparts.com
Back
SP105
SP104
Back to TOC
3. Install the front lip screw into the headlight hous-
ing; then install the screws securing the front
fender supports to the frame.
4. Install the forward underseat fasteners and tighten
the screws only until snug.
5. Install the battery connecting first the positive
cable; then the negative cable.
6. Install the battery hold-down correctly noting that
the front and rear are different; then secure with
the two hold-down screws which are also
through-body mount screws.
Back to Section TOC
SP100
SP102
8
SP099
Next
8-9