Arctic Cat DVX 400 2008 Service Manual page 126

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
11. Remove the cotter pin, steering post nut (5),
washer (6), and dust seal (7) accounting for the
O-ring (8); then remove the steering post holder
cap screws.
12. Remove the hose and cable guide; then remove the
steering post holder.
www.mymowerparts.com
Back
8-4
SP405
SP406
SP407
SP408
Back to TOC
13. Remove the steering post (9); then remove the dust
seals (10), and the steering post holder half (11).
14. Remove the dust seals (12) from the steering post;
then clean all removed parts in parts-cleaning sol-
vent.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Wash the tie rod ends in parts-cleaning solvent.
Dry with compressed air. Inspect the pivot area for
wear. Apply a low-temperature grease to the ends.
! WARNING
Always wear safety glasses when using compressed
air.
2. Inspect the tie rods for damaged threads or wear.
3. Inspect the tie rods for cracks or unusual bends.
4. Inspect all welded areas for cracks or deteriora-
tion.
5. Inspect the steering post and steering-post holders
for cracks, bends, or wear.
6. Inspect the handlebar clamps for cracks or wear.
7. Inspect the handlebar for cracks, wear, or unusual
bends.
Back to Section TOC
SP409
SP410
Next