Wheels And Tires - Arctic Cat DVX 250 2007 Service Manual

8. Connect the tie rod ends to the steering knuckle;
then tighten the nut to specifications and install
a new cotter pin.
NOTE: During assembly, new cotter pins should
be installed.

Wheels and Tires

TIRE SIZE
! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable ATV
operation.
The ATV is equipped with low-pressure tubeless
tires of the size and type listed (see Section 1). Do
not under any circumstances substitute tires of a dif-
ferent type or size.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the ATV and could
cause excessive drive train damage not covered by
warranty.
Back
7-10
KM569
KM581
Back to TOC
TIRE INFLATION PRESSURE
Tire inflation pressure should be as specified.
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove the wheels.
NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean the wheels and hubs with parts-cleaning
solvent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs,
and leaks.
INSTALLING
1. Install each wheel on its hub.
Back to Section TOC
SP054
Next