Arctic Cat DVX 400 2008 Service Manual page 86

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Install the washer (1), drive pin (2), and driven
gear (3); then install the circlip (4). Make sure the
circlip is properly seated.
INSTALLING
1. Install a new O-ring in the water pump case; then
attach the case to the clutch cover.
www.mymowerparts.com
Back
SP305
SP307A
SP309
Back to TOC
2. Install the clutch cover and tighten the cap screws
securely; then install the master cylinder mounting
bolts and tighten to specifications (see Section 10).
3. Connect the brake switch spring and the brake
pedal spring.
4. Connect the radiator hose; then fill the cooling
system with the recommended amount of coolant.
NOTE: While the cooling system is being filled,
air pockets may develop; therefore, run the engine
for five minutes after the initial fill, shut the engine
off, and then fill the cooling system.
5. Refill the engine oil tank; then run the engine for
several minutes and check for leaks. Recheck the
engine oil and coolant levels.
6. Check the entire cooling system for leakage.
! CAUTION
After operating the ATV for the initial 5-10 minutes,
stop the engine, allow the engine to cool down, and
check the coolant level. Add coolant as necessary.
Back to Section TOC
SP310
4
AN604D
Next
4-13