Arctic Cat DVX 400 2008 Service Manual page 114

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
NOTE: Removed bushings must be replaced with
new ones.
5. To inspect front and rear arm bearings, insert the
spacer into the bearing; then check for excessive
play by moving the bearing up and down. If exces-
sive play is noted, the bearing must be replaced.
6. Remove the dust seals; then using a suitable bear-
ing puller and slide hammer, remove the defective
bearing.
NOTE: Removed bearings must be replaced with
new ones.
www.mymowerparts.com
Back
SP350
SP351
SP352
Back to TOC
7. Remove the front arm bearings using a suitable
bearing puller set.
NOTE: Removed bearings must be replaced with
new ones.
8. To check pivot shaft runout, use a dial indicator. If
runout exceeds 0.3 mm (0.01 in.), replace the pivot
shaft.
Back to Section TOC
SP353
SP354
7
SP355
Next
7-9