Wheels And Tires - Arctic Cat Y-12 2008 Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
9. Place the axle housing into position on the
swing arm; then install and tighten four cap
screws to specifications.
10. Install the brake caliper on the axle housing with
the two cap screws. Tighten securely.
11. Install the wheels and tighten the cap screws to
specifications; then remove the ATV from the
support stand.
! WARNING
After removing and installing of components that
are brake-related, ALWAYS check and adjust brakes
as necessary before operating the ATV.
www.mymowerparts.com
Back
7-8
MD2014
KM229
Back to TOC

Wheels and Tires

TIRE SIZE
! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable ATV
operation.
The ATV is equipped with low-pressure tubeless
tires of the size and type listed (see Section 1). Do
not under any circumstances substitute tires of a dif-
ferent type or size.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the ATV and could
cause excessive drive train damage not covered by
warranty.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.21
2
kg-cm (3.0 psi).
! WARNING
Always maintain proper tire inflation pressure.
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove the four cap screws securing each
wheel; then remove the wheels.
NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
Back to Section TOC
Next