Cannot Send Via Voip Gateway - Ricoh D117 Service Manual

11 Network bandwidth too narrow?
12 Remote fax cancelled transmission?

Cannot send via VoIP Gateway

Check Point
1 LAN cable connected?
2 VoIP Gateway T.38 standard?
3 VoIP Gateway installed correctly?
4 VoIP Gateway power switched on?
Is the IP address/host name of the
5
specified Gateway correct?
6 Number of the specified fax correct?
7 Firewall/NA T is installed?
8 Transmission sent manually?
9 IP address of local fax registered?
DNS registered when host name
10
specified?
11 Remote fax a G3 fax?
SM
Request the network administrator to
increase the bandwidth.
Raise the delay level.
IPFAX SW 01 Bit 0 to 3
IP-Fax bandwidth is the same as the
DCS speed. Set IP-Fax SW00 Bit 6 to
1.
Check whether the remote fax
cancelled the transmission.
Action
Check the LAN cable connection.
Contact the network administrator.
Contact the network administrator.
Contact the network administrator.
Check the IP address/host name.
Check the remote fax number.
Cannot breach the firewall. Send by
using another method (Fax, Internet
Fax)
Manual sending not supported.
Register the IP address.
Contact the network administrator.
Check that the remote fax is a G3 fax.
45
IP-Fax Troubleshooting
D649