Replacing An Mpu And A Switching Fabric Module; Prerequisites; Replacing An Mpu; Replacing An Sfe-X1 - HP FlexNetwork HSR6800 Installation Manual

Replacing an MPU and a switching fabric module

Prerequisites

•
If the router is installed with only one MPU, make sure all power sources to the router are turned
off before replacing the MPU.
•
If the router is installed with two MPUs, make sure both MPUs operate correctly before
replacement.
To replace the active MPU, execute the slave switchover command to trigger an active
and standby switchover. For more information about the slave switchover command, see
HPE FlexNetwork HSR6800 Routers High Availability Command Reference.
To replace the standby MPU, remove it directly.

Replacing an MPU

The replacement procedures for the RSE-X2 and RSE-X3 MPUs are the same. The following
procedure uses an RSE-X2.
To replace an MPU:
Face the front of the router and locate the MPU to be removed.
1.
Use a Phillips screwdriver to completely loosen the captive screws of the MPU.
2.
Holding the ejector levers of the MPU with both hands, pull the ejector levers outward, and
3.
gently pull the MPU out of the slot along the slide rails.
Figure 43 Pulling the RSE-X2 MPU out of the slot
Install a new MPU. For the installation procedure, see
4.
If you do not install a new MPU in the slot, install a filler panel.

Replacing an SFE-X1

Face the front of the router and locate the SFE-X1 to be removed.
1.
Use a Phillips screwdriver to completely loosen the captive screws on the SFE-X1.
2.
Holding the ejector levers of the SFE-X1 with both hands, pull the ejector levers outward, and
3.
gently pull the SFE-X1 out of the slot along the slide rails.
"Installing an
39
MPU."