HP FlexNetwork HSR6800 Installation Manual page 97

NOTE:
The dialup function for an AUX port is supported only on Comware V5. For MPU and Comware
compatibility, see
Management Ethernet port
The management Ethernet port is a 10Base-T/100Base-TX/1000Base-T autosensing RJ-45 port. It
allows you to upgrade software and manage the router through a network management server
without using any service interface of the router. The management Ethernet port is used only for
managing the router and it has no service processing capabilities such as data forwarding.
Table 40 Management Ethernet port specifications
Item
Connector
Interface type
Ports
Supported frame format
Interface speed and duplex mode
Transmission medium and maximum transmission
distance
NOTE:
• The media dependent interface (MDI) standard is typically used on the Ethernet port of network
adapters.
• The media dependent interface crossover (MDI-X) standard is typically used on hubs or LAN
switches.
Reset button
CAUTION:
• If you perform no save operation before resetting the router, the current system configuration will
be lost.
• To prevent damage to the file system, never press the RESET button when the RUN LED is
flashing fast or when the router is accessing the CF card or a USB storage device.
To reset the current MPU, press the RESET button.
•
If you press the RESET button when only one MPU is equipped, the entire system will be reset.
•
To perform an active/standby switchover when two MPUs are equipped, press the RESET
button on the active MPU. The system automatically switches the services to the standby MPU,
without interrupting ongoing services.
•
If you press the RESET button on the standby MPU when two MPUs are equipped, the standby
MPU will be reset but the system operation will not be affected.
The RUN LED goes off when the MPU is reset, flashes fast (at 8 Hz) when BootWare is running, and
flashes slowly (at 1 Hz) after the system is booted and operating correctly.
"MPU and Comware compatibility matrix."
Specification
RJ-45
MDI/MDIX autosensing
1
Ethernet_II
Ethernet_SNAP
•
10 Mbps, half/full duplex
•
100 Mbps, half/full duplex
•
1000 Mbps, full duplex
Crossover, category-5 twisted pair cable, with a
maximum transmission distance of 100 m (328.08 ft)
91