Replacement Procedure; Replacing A Power Module; Replacing An Air Filter - HP MSR2000 Series Manual

Replacement procedure

IMPORTANT:
The barcode on the router chassis contains product information that must be provided to local sales

agent before you return a faulty router for service.
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open the

chassis, contact HP for permission. Otherwise, HP shall not be liable for any consequence.

Replacing a power module

The replacement procedure of an AC power module is the same as a DC power module. This section
uses an AC power module as an example.
To replace a power module:
Locate the power module to be removed and use a Phillips screwdriver to completely loosen the
1.
captive screws of the power module.
Holding the handle of the power module with one hand and supporting the bottom of the power
2.
module with the other hand, gently pull the power module out of the slot along the slide rails.
Put the removed power module on an antistatic workbench or into an antistatic bag.
Figure 50 Pulling a power module out of the slot
Install a new power module. For the installation procedure, see "Installing the router."
3.
Install a filler panel if you do not install a new power module.

Replacing an air filter

Use a Phillips screwdriver to completely loosen the captive screws of the air filter.
1.
Gently pull the air filter out along the slide rails.
2.
i